|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: pic: Toughbox Mini Bound Up On AM14U3 KoP Chassis
Guess I’ve done a poor job communicating the issue, a better way would have been as GeeTwo has stated
“This would only be feasible if, rather than the journal being cut too short, the hex part of the shaft is cut too long.” Or when the round journal was turned on the hex shaft, normally from .520 to .780. It is only turned from .520 to .720, making the bearing extend .60 farther into the Mini housing. Which was corrected by installing a thinner .220 bearing replacing the .280. |
|
#2
|
|||||
|
|||||
|
Re: pic: Toughbox Mini Bound Up On AM14U3 KoP Chassis
Quote:
Our issue wound up being the plastic housing. I did a few measurements which seemed OK, but I did not measure everything. Swapping it out appears to have solved the problem. That housing went to the dumpster Saturday so we don't use it again. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|