|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
||||
|
||||
|
Re: Reducing noise on the MaxBotix ultrasonics?
As long as the sensor is fairly parallel to the wall, there shouldn't be too much noise (±0.5-1 cm). How are you reading the value? Over the analog output?
You might try accumulating 5-6 readings then taking the median. Are you currently using a single sensor? We tried using two, but gave up because of the noise. Last edited by codetheweb : 31-01-2017 at 11:05. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|