|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
||||
|
||||
|
Re: Tubing for ball intake
No, there is definitely 3 different conversations in this thread.
|
|
#17
|
||||
|
||||
|
Re: Tubing for ball intake
Yup, there are 3 different answers for an ambiguous question here...
|
|
#18
|
||||
|
||||
|
Re: Tubing for ball intake
Quote:
Also I just ordered the components to try this out for myself... should be interesting. Last edited by Skyehawk : 30-01-2017 at 13:52. |
|
#19
|
||||
|
||||
|
Re: Tubing for ball intake
Quote:
Can't tell you which way is faster, it may very well be that yours is... |
|
#20
|
||||
|
||||
|
Re: Tubing for ball intake
Quote:
I will post a reminder in our team slack to put the video together during our next meeting on Wed. |
|
#21
|
||||
|
||||
|
Re: Tubing for ball intake
Quote:
How do you adjust the ends of the rollers? i.e. move the last inch of the latex up to your mark on the Al tubing? |
|
#22
|
||||
|
||||
|
Re: Tubing for ball intake
Quote:
|
|
#23
|
|||||
|
|||||
|
Re: Tubing for ball intake
Quote:
|
|
#24
|
||||
|
||||
|
Re: Tubing for ball intake
We would appreciate that video very much as we are putting our intake together this week with the same set up for the first time.
|
|
#25
|
||||
|
||||
|
Re: Tubing for ball intake
Quote:
The "sticky when dry" caveat, however, should not be ignored. A 20" wide roller has only the two ends of the rubber tubing to facilitate evaporation. Four sections, each 5" wide, however, might allow for fairly rapid evaporation of the hairspray... |
|
#26
|
||||
|
||||
|
Re: Tubing for ball intake
I might as well do a round belt welding video at the same time. What other intake and conveyor stuff would you like me to add to the to-do list?
|
|
#27
|
||||
|
||||
|
Re: Tubing for ball intake
How to make poly round belts have identical tensions so they don't 'wander' on the rollers.
|
|
#28
|
||||
|
||||
|
Re: Tubing for ball intake
If it's not too late, probably also replacing polycord tubing and belting - I've seen both designing for accessibility and forming the bands on the roller
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|