|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Ni Web Based Configuration Not Showing CAN Talons
Hi,
I'm programmer for 2523, and I'm trying to get the NI Web based config up and running now that our electronics board is put together, so as to configure the CAN Talons we are using for our drive train. After updating the firmware on both the wireless access and the RoboRIO, I was able to access the configuration menu via roboRIO-2523-FRC.local, but the roboRIO is the only thing that shows up. The CAN talons do not, and the driver station does not even register any communication with the RIO. Also, the COMM light on the RIO does not turn on at all. Does anyone have any idea what could be causing this, or at least whether it's a hardware or software issue? Side Note: This is my first post on here, so let me know if this is in the wrong place. |
|
#2
|
|||||
|
|||||
|
Re: Ni Web Based Configuration Not Showing CAN Talons
There are three things:
- updating roboRIO firmware (not necessary if it's at 3.0.0) The version is listed on the roboRIO web interface. - formatting the roboRIO (puts the operating system onto the roboRIO-has the web interface) - Downloading user code Did you install the 3rd party CAN Talon Toolsuite, too? The CTRE LifeBoat utility also has a tab to update the CTRE products on the roboRIO. http://www.ctr-electronics.com/talon...ical_resources Last edited by Mark McLeod : 04-02-2017 at 18:03. |
|
#3
|
||||
|
||||
|
Re: Ni Web Based Configuration Not Showing CAN Talons
Some trouble shooting tips:
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|