|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
|
||||
|
||||
|
Re: E4T Encoder Help
So from what I can tell, your DIO 6 (channel B) seems to be disconnected. Connect up a multimeter (or a oscilloscope if you're feeling fancy) and see if you can get a signal anywhere on the wire (at the connector to the encoder, solder joint to the board). From there you can figure out which portion you need to replace.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|