|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
OM5P-AN Flashing Timeout
Every time I try to flash the new radio (using FIRST's utility), I get the error message "Bridge firmware load failed: Timeout flashing radio." It's able to detect when I power-cycle the radio, and begins to flash, but then just times out and never finishes. Firewall is disabled and the program is run as administrator. Anyone have any ideas?
|
|
#2
|
|||
|
|||
|
Re: OM5P-AN Flashing Timeout
The KOP radio should already have the right firmware.
Have you tried these instructions for flashing the firmware? http://files.andymark.com/OM5P-AN_QuickAP_Setup.pdf |
|
#3
|
|||
|
|||
|
Re: OM5P-AN Flashing Timeout
Quote:
|
|
#4
|
|||
|
|||
|
Re: OM5P-AN Flashing Timeout
Quote:
http://www.andymark.com/OM5P-AN-p/am-3277.htm |
|
#5
|
|||
|
|||
|
Re: OM5P-AN Flashing Timeout
The instructions on the AndyMark page are for non-FRC use applications.
For FRC, you'll want to follow the directions here: Programming for Home Use for FRC |
|
#6
|
|||
|
|||
|
Re: OM5P-AN Flashing Timeout
The andymark instructions worked for me. We could not get the frc configutation tool to work.
|
|
#7
|
|||
|
|||
|
Re: OM5P-AN Flashing Timeout
I was getting the same error.
I then tried to use the flash tool under the: C:\Program Files (x86)\FRC Radio Configuration Utility which worked for others. Except, the unit for 2017 is OM5P-AC but the firmware didn't work and I received this error: is of type 'OM5P-AC' that we have no image for I then followed this - https://help.cloudtrax.com/hc/en-us/...d-access-point In my case, step 2 and 4 did the trick for me. Note, I have the NI Suite installed on my Win10 Surface Book. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|