|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#31
|
||||
|
||||
|
Team #365
# of years of participation? 4 # and type of motors? 2 Bosch's, 2 CIM's # and type of drive wheels? 4 custom 6" aluminum wheels with neoprene wrapped around, attached by tie-wraps. # and type of non-drive wheels? 0 Transfer system(chains, belts, etc.)? Chain, independent to each wheel Transmission (not including supplied ones)? 2 custom, we geared the CIM's down to the same as the bosch's in the low setting. Steering? Skid steering Sensors? Two gyro's for autonomous, one for the turn to go up the ramp, one to stop the robot once we got off the ramp. Success? Everything worked as planned. It was a fairly simple system, so, nothing major broke. Good combination of speed and torque. Problems? The only problem we ran into was a chain falling off (twice). Next year? We're looking into hovercraft, and a form of a mag-lev vehicle. No, but we're exploring several more advanced options. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drivetrain mouts and gears | Andrew Dahl | Technical Discussion | 3 | 22-01-2003 13:21 |
| My team is toying with drivetrain ideas .. . | Frank(Aflak) | Technical Discussion | 12 | 10-01-2003 21:52 |
| Best source for gears? Smallparts? drivetrain advice wanted! | Frank(Aflak) | Technical Discussion | 11 | 10-01-2003 17:22 |
| What motors power your drivetrain? | Khalicl13 | Motors | 35 | 03-12-2002 16:33 |
| Computer modeling of drivetrain and devices | archiver | 2000 | 1 | 23-06-2002 23:02 |