Pressing Pinion on the Chipper

by the way when someone calles me a dork or geek, i tell them to look up dork and geek in the dictionary, and that i would rather be called nerd :) - Mike Schroeder [more]

		Chief Delphi > Technical > Technical Discussion
Pressing Pinion on the Chipper

View First Unread

Thread Tools

Rate Thread

Display Modes

25-01-2002, 16:48

JamesJones JamesJones is offline

Registered User

#0180 (SPAM)

Join Date: Jan 2002

Location: Stuart, Fl

Posts: 44

JamesJones is an unknown quantity at this point

Pressing Pinion on the Chipper

Does anyone know what the inside of a Chip' motor looks like? I would like to press a different pinion on the output shaft/gear but don't want to damage anything inside (bearings).

Any advice or suggestions (Dr. Joe) would be appreciated.

Thanks.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
BOSCH motor pinion pitch	Matt Reiland	Technical Discussion	2	10-01-2003 09:26
new bosch pinion and mounting	ajlapp	Motors	1	08-01-2003 17:16
Chiaphua Motor Pinion Gear	Joe P	Inventor	0	27-02-2002 15:48

All times are GMT -5. The time now is 18:44.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.