|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
|||
|
|||
|
Re: How do you program the navx mxp in labview?
The LabView installation link doesn't seem to work. I downloaded the library from GitHub, but where do I install it?
|
|
#17
|
|||
|
|||
|
Re: How do you program the navx mxp in labview?
Quote:
http://www.pdocs.kauailabs.com/navx-mxp/software/ Download the zip, and run the setup.exe within it. It will install everything you need. There is a tutorial a couple of links under that page http://www.pdocs.kauailabs.com/navx-...aries/labview/ |
|
#18
|
|||
|
|||
|
Re: How do you program the navx mxp in labview?
I am able to download the .zip but when I try to extract it, it gives me an error.
|
|
#19
|
|||
|
|||
|
Re: How do you program the navx mxp in labview?
Which is why I said it doesn't work. Downloading the library directly from GitHub does work, but where do we install it?
|
|
#20
|
|||
|
|||
|
Re: How do you program the navx mxp in labview?
Just found out there was a temporary file that was corrupted on the download site, so please download it again and run the setup.exe which will install everything into the proper place.
|
|
#21
|
|||
|
|||
|
Re: How do you program the navx mxp in labview?
Do we need to set a device number on the navX Main in Robot Main?
|
|
#22
|
|||
|
|||
|
Re: How do you program the navx mxp in labview?
No, you do not need to wire anything to the Device Number or the Update inputs per the video tutorial linked to above.
![]() |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|