|
|
|
 Measure it with a micrometer, mark it with chalk, and cut it with an axe. This is not an exact science. - Jim Meyer [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Measure it with a micrometer, mark it with chalk, and cut it with an axe. This is not an exact science. - Jim Meyer [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Gear and Timing Pulley Design Resources
Howdy,
I was wondering if any of the more experienced folks out there knew of a good online resource that explains gear and timing pulley design. In the past Ed Sparks had a good spreadsheet on his website that detailed the various dimensions of a sprocket. I'm looking for a similar resource for gears and for timing pulleys. ...I've been trying to make a timing pulley in Inventor, working with specifications from F.N. Sheppard, and I can get it close, but it never turns out right. For 1/2" pitch belt and a 2.81" outer diameter, I end up expecting 17.655 pitches -- and the specifications call for 18. Help! |
|
#2
08-05-2003, 15:36
|
||||
|
||||
|
http://www.wmberg.com/tools/
this site has TONS of information, and a few good tools on the above page. The convert program I use all the time (the General Unit Conversion Utility) |
|
#3
08-05-2003, 21:01
|
||||
|
||||
|
If you check out my other thread, you'll see that Boston Gear has a very comprehensive guide on gear design.
http://www.chiefdelphi.com/forums/sh...threadid=20603 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
