|
|
|
 if sleep is essential, then yeah, I'm in trouble. - Eria4044 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| if sleep is essential, then yeah, I'm in trouble. - Eria4044 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
28-01-2002, 20:18
|
||||||
|
||||||
|
Actually, I asked this question a little while ago. Dr. Joe answered with this:
"As to asymmetry in the Chiaphua's. I think that the brushes are symmetric, but I am not going to risk taking the motors apart to find out (by the way, if you do, don't take the armature out of the magnets -- again I have REAL DATA to show that you can lose as much as 10% of the output of the motor by simply taking the armature out of the housing and putting it back in again -- it is a magnitism thing I have been told). " Seems like that's the best answer we're gonna get.  ~Christina |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drill Motor Speed Difference | Mark Jones | Motors | 2 | 14-02-2003 15:23 |
| forward reverse on drill motor | PDonovan | Motors | 2 | 03-02-2003 11:11 |
| Speed Reduction for Drill Motors | Ian W. | Programming | 5 | 18-01-2003 23:57 |
| Relay Outputs | OddOne | Technical Discussion | 3 | 01-02-2002 19:52 |
Threaded Mode