metric gears - Chief Delphi

18-05-2003, 09:53

Matt Reiland Matt Reiland is offline

'The' drive behind the drive

None #0226 (TEC CReW Hammerheads)

Team Role: Engineer

Join Date: May 2001

Rookie Year: 1999

Location: Troy Michigan

Posts: 712

Matt Reiland has a reputation beyond repute

Nope, they are the only source that I have found also.

I would recomend ordering a few in the off season since they take a minimum of two weeks to get and they aren't very expensive.

This year we used a 48 tooth to lower the drill down to the Atwood and it worked very well as far as power goes.

__________________
Robonaut Next Generation Control System Development

2003 GLR Champions (302,67,226)
2003 Buckeye Semi-Finalists(902,494,226)
2002 Nationals QuarterFinalists
2001 West MI QuarterFinalists
2000 GLR Semi-Finalists

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Helical gears that come with new drill motor	Joe P	Technical Discussion	4	12-01-2003 11:09
Best source for gears? Smallparts? drivetrain advice wanted!	Frank(Aflak)	Technical Discussion	11	10-01-2003 17:22
gears....?	archiver	2000	16	23-06-2002 22:58
Need help! What kind of gears are we allowed to use??	Randy_Ai	Technical Discussion	3	23-01-2002 22:56
How do i make gears in inventor?	mnkysp6353	Inventor	1	16-01-2002 02:31

All times are GMT -5. The time now is 02:24.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.