Mounting Drill Motors Using Plastic Housing

PS. Listen to the wise Brandon Martus. Think before you (re)act. - artdutra04 [more]

		Chief Delphi > Technical > Motors
Mounting Drill Motors Using Plastic Housing

Thread Tools

Rate Thread

Display Modes

30-01-2002, 15:47

Matt Leese Matt Leese is offline

Been-In-FIRST-Too-Long

FRC #1438 (The Aztechs)

Team Role: Engineer

Join Date: May 2001

Rookie Year: 1998

Location: Long Beach, CA

Posts: 937

Matt Leese has a reputation beyond repute

First of all, just place them in the drill motor housing. Then, cut off the handle of the drill motor and mount them so that they would be right side up for a drill. Then just secure them at the top and they should reasonably stay in place.

Matt

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
plastic hubs and drill motors	Will Camisa	General Forum	4	01-03-2003 00:03
Complete Drill, Seat, and Window motors for trade	archiver	2000	0	23-06-2002 22:16
Complete Drill, Seat, and Window motors for trade	archiver	2000	0	23-06-2002 22:16
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32
what about the drill motors?	Ken Leung	Motors	2	26-06-2001 02:11

All times are GMT -5. The time now is 00:59.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.