|
|
|
 What Delphi says doesn't matter. What the official Q&A says matters. - Tetraman [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| What Delphi says doesn't matter. What the official Q&A says matters. - Tetraman [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#12
30-01-2002, 21:56
|
|||
|
|||
|
Tell me if i am wrong but only people over the age of 18 can use Milling machines and lathes right? I tried to get a job learning the lathe and the milling machine at age 17 and they could not accept me because of my age. However now i am one of 2 students that machines and my father is a machinist so i can ask him to do it if i cannot do it (ie gears and sprockets [oops did i give to much info about our robot this year]). Oh well, I hope everyone is still having fun!!!!
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Girls: What beauty tips do you give to other girls for Competions? | Brm789 | Chit-Chat | 140 | 02-03-2004 12:51 |
| Does your school give your team money? | Joe Menassa | General Forum | 17 | 15-01-2002 19:16 |
| What advice would you give? | Jessica Boucher | Technical Discussion | 3 | 03-12-2001 07:44 |
| What advice would you give? | Jessica Boucher | General Forum | 8 | 02-12-2001 07:10 |
| Time to give a little back to FIRST? | Elgin Clock | General Forum | 0 | 05-11-2001 19:15 |
Threaded Mode