|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
|||||
|
|||||
|
Re: Globe
Quote:
Or just a really-really sharp hack saw and go to town!! ![]() |
|
#17
|
|||||
|
|||||
|
Nah not even a plasma cutter or hacksaw...
Just find a really small drill bit and a drill..... Taking apart a Globe just requires some time. Drill away all 3 of those roll pins that connect the Globe motor to the Globe gearbox. (you wont get it back together....) :-) |
|
#18
|
|||||
|
|||||
|
As my little buddy brad pointed out yes it does take some time it took the two of us close to 30 minutes to drill out those 3 pins. They are really long. I dont recoment this if you plan on using the globe again. On a different note the globe is actually a really fast motor with out the gear box.
|
|
#19
|
|||||
|
|||||
|
This picture was useful for me, I'm using it to make a Bosch motor in Inventor. I'm planning on animating each peice in 3DS Max by itself, and then combining them into one working motor.
|
|
#20
|
||||
|
||||
|
Coco: if you get a chance, would you mind e-mailling me a copy of that Bosch motor in Pro/E, STEP, IGES format? (Address in profile, or PM me.)
Thanks. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Portable cordless drill press | Gui Cavalcanti | Technical Discussion | 25 | 03-08-2003 22:21 |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| Emergency drill trade/sell | Anarkissed | General Forum | 3 | 16-02-2003 22:37 |
| A new record for breaking a drill motor | ZacharyD | Technical Discussion | 23 | 16-01-2003 16:58 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |