|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||
|
|||
|
I haven't looked at the switches yet, but did your try swapping
pressure gauges? Also what is the measured output on the compressor regulator - Ours certainly was tripping at 120 and the secondary was at sixty. Find it hard to believe both swtiches were so far off. I am not sure if the switches are adjustable. I also noted (much to my chagrin) that there were many leaks the first time I put the system together. Especially at the pressure tanks. Getting the teflon tape right takes a little practice. Use a spray bottle of soapy watter to test your connections. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pneumatic system pressure | illumanat'i | Pneumatics | 6 | 31-01-2003 00:46 |
| Quick Optical Sensor Question | zorro | Technical Discussion | 10 | 21-01-2003 06:39 |
| Auto Air Pump Code | zorro | Programming | 25 | 05-01-2003 16:50 |
| pressure sensors | archiver | 2001 | 0 | 24-06-2002 02:15 |
| Need help with 255 Variable | Joseph F | Programming | 18 | 26-02-2002 14:49 |