PC Interfacing - Chief Delphi

If this information is not 100% correct, you should follow the default advice I have for when anything goes wrong: Blame the Programmers - IKE [more]

		Chief Delphi > Technical > Programming
PC Interfacing

Thread Tools

Rate Thread

Display Modes

05-08-2003, 13:46

lkeller

Registered User

#0857 (Superior roboworks)

Join Date: Aug 2003

Location: MI

Posts: 2

lkeller is an unknown quantity at this point

PC Interfacing

I heard somewhere that It is possible to interface the Basic stamp through one of its ports (i think the dashboard port) to a PC and that one could actually outsource proscessing to the PC. I was wondering if someone could point me in the wright direction. I was basically under the understanding that one could wright code on a pc and then use the PC to read from the stamp's imputs and then send comands to it. Is this true? A little help?

Thanks

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Interfacing a second Micro to the RC	Matt Reiland	Programming	3	08-06-2003 00:11

All times are GMT -5. The time now is 00:34.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.