Thickness of aluminium bars

Randy_Ai · #1 04-02-2002, 17:33

HI guys,

I was just wondering, is there a maximum thickness to the aluminium bars/sheets that we're using?

Thanks.

Matt Reiland · #2 04-02-2002, 20:09

I believe the max thickness is 1/4" for the plate as for the tube which is probably considered an extrusion its something like 2X3" max and you can have whatever thickness you want

Check both them for sure in the Additional Hardware section

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Question about Plywood thickness	KennethToronto	Technical Discussion	4	06-02-2002 15:20
gear thickness	zarb	Technical Discussion	10	26-01-2002 22:07
Aluminium Clarification 10-10-01	Mike Martus	OCCRA	3	18-10-2001 07:55
Aluminium Clarification	Mike Martus	Off-Season Events	2	11-10-2001 10:17