|
|
|
 in FIRST it's not just about where you finish in the standings but the intangible of inspiration where there is no true or immediate forum of measurement. - Koko Ed [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| in FIRST it's not just about where you finish in the standings but the intangible of inspiration where there is no true or immediate forum of measurement. - Koko Ed [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
shaft coupling
We have a problem with our drill couplings that we bought from SPI. We have installed them -- drilled and put a pin in as instructed -- and they are not true. Has anyone else experienced this? Does anyone have any advice?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can you stop a pneumatic pump at half shaft | mjt902 | Pneumatics | 16 | 06-02-2003 11:58 |
| using set screw or dowel pin/pin to hold on drill motor coupler thinggy | Travis Covington | Motors | 1 | 04-02-2002 03:02 |
| shaft drive | Joseph F | Technical Discussion | 5 | 03-02-2002 17:51 |
| Big Shaft to Little Shaft? | Anton Abaya | Technical Discussion | 7 | 21-01-2002 19:27 |
| 3.5x3.5 coupling? | ahecht | Technical Discussion | 1 | 05-01-2002 23:36 |
Threaded Mode