|
|
|
 When twenty people tell you your hair is on fire, you don't need to look into a mirror to find out they're right. - IndySam [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| When twenty people tell you your hair is on fire, you don't need to look into a mirror to find out they're right. - IndySam [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
04-02-2002, 19:50
|
||||
|
||||
|
We had zero problems with the SPI couplings.
We used a 1/8" keyway on the drive shaft to mate with the keyway in the coupling and a 1/16" Steel roll pin on the drill motor shaft (threaded end) as specificed by the SPI documentation. We have not experienced any problems and have been testing (beating up) the drive train for about 1 week now. We should be ready for FULL bot testing (read FULL WEIGHT) within the next 2 days. I'll be sure to post any problems if they arise. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can you stop a pneumatic pump at half shaft | mjt902 | Pneumatics | 16 | 06-02-2003 11:58 |
| using set screw or dowel pin/pin to hold on drill motor coupler thinggy | Travis Covington | Motors | 1 | 04-02-2002 03:02 |
| shaft drive | Joseph F | Technical Discussion | 5 | 03-02-2002 17:51 |
| Big Shaft to Little Shaft? | Anton Abaya | Technical Discussion | 7 | 21-01-2002 19:27 |
| 3.5x3.5 coupling? | ahecht | Technical Discussion | 1 | 05-01-2002 23:36 |
Threaded Mode