|
|
|
 Welcome to FIRST, the place where you can be competitive in a team. Here people can learn more in one year of FIRST than in four years of high school. - dude__hi [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Welcome to FIRST, the place where you can be competitive in a team. Here people can learn more in one year of FIRST than in four years of high school. - dude__hi [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
We have access to 5 mills (and 2 NC's) and go with 30x30 still. I was pretty sure they still made connecting hardware for 20x20. Anyway, we make out own conecting pieces (out of 1/4" plate BTW) because the Bosch ones are just too expensive. We use all right angles and have no problem. We could do a custom angle if we wanted though, we would just need new connector plates of have it welded. However, we broke a steel wels, I don't think we'll try our luck at aluminum (the weld was good but the force on it was much)
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| the provided chassis material | Andrew Dahl | Kit & Additional Hardware | 5 | 09-01-2003 15:26 |
| Preseason project | AdamT | General Forum | 4 | 09-09-2002 00:52 |
| project box | archiver | 2000 | 2 | 23-06-2002 23:01 |
| physics project | SharkBite | General Forum | 10 | 03-03-2002 22:06 |
| MS Project Build Schedule | joe_balint | Technical Discussion | 1 | 07-01-2002 03:25 |
Hybrid Mode
