How to wire a 40 Amp Breaker?

07-09-2003, 13:20

rbayer

Blood, Sweat, and Code

no team (Teamless Orphan)

Join Date: Mar 2002

Rookie Year: 2001

Location: Minnetonka, MN

Posts: 1,087

Well, basically you just run some 6awg wire from the 120amp to the metal contact plate/screw on the 40amp block. You then connect one of the wires coming out of the 40amp block (there should be four of them) to each speed controller you want to power. You get the ground for the speed controller from the 20/30amp block.

__________________
New C-based RoboEmu2 (code simulator) available at: http://www.robbayer.com/software.php

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
60 amp Circuit Breaker Info	archiver	2001	1	23-06-2002 22:33
Motor wire sizes	Tim Skloss	Motors	5	13-02-2002 07:44
wire question	James Crivellone	Electrical	1	13-02-2002 07:32
60 amp breaker	Anne Lam	Technical Discussion	10	10-01-2002 15:13
Chain and chain breaker source?	kmcclary	Off-Season Events	4	22-10-2001 22:51

All times are GMT -5. The time now is 17:32.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.