|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
|||||
|
|||||
|
Now that the bandages have come off my hand, I can type again...
We have a 60-tooth gear meshing with the 16-tooth portion of the Chiaphua pinion, which gives a 18.3:1 reduction. This is driving a 5.25" diameter wheel. At 5500 rpm from the Chiaphua, you get a design speed of ~ 5 fps at normal load (modified by the efficiency loss from the gearbox, which we have not measured yet). -dave ---------------------------------- Team 116: Creating the technologies of tomorrow, sometime late tonight. |
|
#17
|
|||
|
|||
|
Hot Motors
We use both chiuppa motors for our drive drain and we ran the robot yesterday for an hour practicing towing a goal etc...
We witnessed no change in temp for the motors. |
|
#18
|
||||
|
||||
|
Our chiaphu motors seem to run fine. THe Bosh motors are always the ones that need cooling.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Choosing a machine shop (Re: How important is a machine shop | archiver | 2001 | 9 | 24-06-2002 04:20 |