|
|
|
 My first reaction was "Where am I am gonna find pool noodles AND inner tubes in the middle of winter in Michigan?" - KTorak [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| My first reaction was "Where am I am gonna find pool noodles AND inner tubes in the middle of winter in Michigan?" - KTorak [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
when I say that i will be tough to make the chips and drills to run at the same speed . . . I do not mean at full power. However, as I understand these things, if you were to take a chip and a drill, gear them so their free RPM's are equal, and then increase the voltage from zero to twelve at the same rate, the different motors will have different rates of increasing . . . ness . . . . osity . . . . or something. I mean, that, while you can sync the motors at 12 volts, they won't nescessarily be synced when you are giving them half power. Does this make sense? So, our base will run a straight line at full speed, but will pull to one side at half power and stuff. This isn't that large a problem, but its something to think about.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Any Tips on the Design of Drives | Argoth | 3D Animation and Competition | 0 | 03-11-2003 22:00 |
| What's the best combination for bot types this year? | authgeek1218 | Rules/Strategy | 5 | 09-01-2003 00:14 |
| Button types | Scottie2Hottie | General Forum | 7 | 27-03-2002 00:13 |
| External Hard Drives... | David Kelly | Chit-Chat | 8 | 01-12-2001 21:28 |
| Music types | Carolyn Duncan | Chit-Chat | 42 | 03-08-2001 23:06 |
Hybrid Mode
