|
|
|
 We were all rookies once, and we really have two ways to go about things: either take a page from the powerhouses and emulate their style, or complain about not having anything and risk falling into oblivion. - George A. [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
Wiper motor isolatiion...
I have taken apart a wiper motor and have Isolated the ground... There are other things that can be done also to make these more friendly for robotics.
If you want, I could provide a procedure for these mods.... What is required is a few torks drivers and a solder iron and some wire and solder wick or solder sucker and an exacto knife... I would be willing TO DO the mods for any team that wants them... Just let me know... It takes about 20 minutes per to do once you have the materials collected... Paul E. Rogers  Team 245 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PWM and burning out motors | patrickrd | Technical Discussion | 7 | 19-06-2003 15:30 |
| Looking for practice motors & extra tape drive parts? | archiver | 2000 | 1 | 23-06-2002 22:54 |
| Suppose you want seat motors... | archiver | 2000 | 0 | 23-06-2002 22:50 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drill Motors | TF8 | Motors | 19 | 12-12-2001 13:13 |
Hybrid Mode
