Need A 0.75" ID bearing .DWG

Tytus Gerrish · #1 20-10-2003, 18:02

i need a dwg of a 3/4 inch inner diamater bearing that was supplied in the 2003 kit, its the one that fits into the Alumnium bearing mount block

Cory · #2 20-10-2003, 19:54

Did you check the FIRST CAD library? there is also another site that has models of all the parts from the 2003 KOP. Its name is escaping me at the moment.

Cory

SpaceOsc · #3 21-10-2003, 18:58

i would like to know about the second site u mentioned cory

Tytus Gerrish · #4 22-10-2003, 09:33

comeon corey, Don't tease Us

patrickrd · #5 22-10-2003, 10:23

Hi Tytus,

SDP-SI and McMaster both provide CAD drawings and .dwg files for their parts. Just go to:

http://www.sdp-si.com

Click on 'order online', 'bearings' and try to find one close to what FIRST provides. Click on the item number and at the bottom of the page that comes up are links to drawings and CAD files.

Also can try: http://www.mcmaster.com

- Patrick

Cory · #6 22-10-2003, 10:55

Im not trying to tease you guys Tytus... I honsetly dont remember the site.

Cory

Clark Gilbert · #7 22-10-2003, 11:23

http://www.firstcadlibrary.com/

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bearing support - Official	Mike Martus	OCCRA	0	24-09-2002 05:26