|
|
|
 The problem was too many penalties with too much room for judgment. - dbSparx [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The problem was too many penalties with too much room for judgment. - dbSparx [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
06-12-2003, 13:02
|
||||
|
||||
|
Re: switch lever exhaust
Here's what you are looking for:
SMC: AN[ ]03 Series Mufflers, specifically from your picture, AN203 (See Page 2) The material is "PP Sintered", or Sintered Polypropylene http://www.smcusa.com/CC_catalogs_31...ea/AN_6009.pdf Last edited by Gadget470 : 06-12-2003 at 13:09. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| spike for pressure switch? | Rob Colatutto | Rules/Strategy | 4 | 23-02-2003 15:42 |
| Using a switch before autonomous operation | KZos550 | Programming | 11 | 04-02-2003 19:12 |
| NEED HELP with Delay loop for compressor relay switch | archiver | 2001 | 10 | 24-06-2002 02:11 |
| Need help with 255 Variable | Joseph F | Programming | 18 | 26-02-2002 14:49 |
| Error found in programming for the pump and pressure switch | sjharobotics | Programming | 4 | 06-02-2002 17:46 |
Threaded Mode