|
|
|
 They are "Human Dream and Inspiration Enablement Devices" but since that takes too long to say and explain I use the word "robot". - Foster [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| They are "Human Dream and Inspiration Enablement Devices" but since that takes too long to say and explain I use the word "robot". - Foster [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Drill Motor Adjustments -Rev vs Forward
Hi, my team has run into a quite a problem. We have our gearboxes mounted with the bosch drill motors running in opposite directions(really no way to fix this).
Our problem truly is that the bosch motors are stronger in forward gear than in reverse! It is a topped off value, ie, they run fine up until the power sent to them reaches a pwm value, and then the right one just stops going faster, while the left one does. We would rather not limit the power to one of the motors, thus killing our top speed, but we would prefer not to limit the speed to half(or so it seems). Anyone have any ideas how to get around this? is there a setting perhaps on the acutal motors as to which direction is forward, and which is reverse? Thanks all, Team 219 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Portable cordless drill press | Gui Cavalcanti | Technical Discussion | 25 | 03-08-2003 22:21 |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| Emergency drill trade/sell | Anarkissed | General Forum | 3 | 16-02-2003 22:37 |
| forward reverse on drill motor | PDonovan | Motors | 2 | 03-02-2003 11:11 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
Threaded Mode