|
|
|
 Curse you and your logic! - Koko Ed [more] |
 |
|
|||||||
|
||||||||
| View Poll Results: How many motors are you using to drive? | |||
| 2 |
  
|
37 | 37.00% |
| 3 |
  
|
5 | 5.00% |
| 4 |
  
|
42 | 42.00% |
| 5 |
  
|
3 | 3.00% |
| 6 |
  
|
8 | 8.00% |
| 7 |
  
|
3 | 3.00% |
| 8 or more |
|
2 | 2.00% |
| Voters: 100. You may not vote on this poll | |||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#12
13-02-2002, 21:12
|
||||
|
||||
|
Woodie said it and update 3 I think
If you remember Woodie Talking in the kickoff, he said that they had run tests on the primary breaker being supplied to the teams.
The breaker is somewhat slow blow. I believe one of the earlier team updates has to results for the test but basically this is what woodie said in the kickoff. -the breaker will last 1 min 48 seconds at 100 amps -the breaker will last 8 seconds at 200 amps. The smaller fuses (for each motor) are fast blow on the other hand. If you draw over their limit for about 1-2 seconds they will blow, but will reset within the span of a match. However you should design your robot such that none of your fuses blow, if you lose power even to a small fuse in the match, you are effectively vulnerable for about 30 seconds as we found out through a bad crimp in the 2000 competition. Hope that answers some questions. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Direct drive or Chain? | Suneet | Technical Discussion | 32 | 27-03-2003 23:00 |
| Looking for practice motors & extra tape drive parts? | archiver | 2000 | 1 | 23-06-2002 22:54 |
| Drill Motors | TF8 | Motors | 19 | 12-12-2001 13:13 |
| Drivetrain Help | Jordan | Technical Discussion | 16 | 02-12-2001 12:14 |
| Swerve Drive | Jeff Waegelin | Technical Discussion | 14 | 17-09-2001 08:06 |
Threaded Mode