|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
|||
|
|||
|
Re: 2D/3D Gear Design
In looking at the bevel gear, what if the gear is created as if it were a simple taper angle. Then, for the outer angle, drawing a hollow cylinder with the appropriate taper on the inside and use subtract. For the inner angle, it would be a solid cylinder with the proper external taper and subtract that.
indieFan |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| gearing design calculation question | caffel | Motors | 4 | 24-03-2003 17:34 |
| Thunder Chicken CCT | Simon G | Motors | 4 | 03-01-2003 13:18 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drivetrain help | thedillybar | Technical Discussion | 9 | 08-01-2002 21:54 |
| Drivetrain Help | Jordan | Technical Discussion | 16 | 02-12-2001 12:14 |