|
|
|
 Did you know that if a G7, G27, G28, and G20 occur in that order at the same time, then the referee will appear to be doing the "YMCA"? :) - Jack Jones [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Did you know that if a G7, G27, G28, and G20 occur in that order at the same time, then the referee will appear to be doing the "YMCA"? :) - Jack Jones [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
12-18-2003, 08:14 PM
|
|||||
|
|||||
|
Re: EDU Default Code for 1 Joystick
In a nutshell: PWM's are speed controllers, which receive a value of 0 to 254 (8-bit) input. 0 is full speed reverse, 254 is full speed forward, and 127 is dead stop.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How long does it take you to load the default code? | vegasmcse | Robotics Education and Curriculum | 10 | 11-03-2003 09:41 PM |
| robot goes haywire with the one joystick default code | Miles | Programming | 7 | 01-24-2003 02:58 PM |
| 2003 PBasic default code from Innovation First | ttedrow | Programming | 0 | 01-06-2003 11:18 AM |
| default code | archiver | 2001 | 2 | 06-23-2002 10:53 PM |
| Rookie Programmer has question about the default code | DanL | Programming | 3 | 01-26-2002 07:59 PM |
Threaded Mode