Pneumatic Layout (Does it work?)

[Matt Fultz]

If anyone could figure out if this verbal model will work, that would be great. If it won't, please say why it wouldn't power the pneumatic cylinder, or say if anything should be added or changed. I could not make a picture of this, so I am just stating all connections.

Compressor to a brass T fitting. The "stem" (vertical) part of the T runs to a pressure gauge, the other end is run to the resevoir. The resevoir runs out to another brass T where the stem runs to a quick connect fitting to run tubing to a double solenoid and the other end of the T runs to a pressure switch to shut off compressor. The tubing runs to the double solenoid and out of the d.s. to the pneumatic cylinder.

If more detail or more parts are needed, please tell me.

Thanks!