Drill+CIMs - Chief Delphi

Just put it in the dryer for a few extra cycles. That should shrink it down nice and small. - notmattlythgoe [more]

		Chief Delphi > Technical > Motors
Drill+CIMs

10-01-2004, 15:34

kevin.li.rit kevin.li.rit is offline

Imaginary Friend

AKA: Kevin Li

FRC #0596 (SciClones)

Team Role: Student

Join Date: Jan 2003

Rookie Year: 2001

Location: Hopkinton, Massachusetts

Posts: 936

Drill+CIMs

The Drill and CIMs are the same as last year, correct?

__________________
Kevin Li

596 - Sciclones
1405 - Finney Falcons
2262 - Holliston Panthers

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Portable cordless drill press	Gui Cavalcanti	Technical Discussion	25	03-08-2003 22:21
drill motor mounts- again	Jeff Sharpe	Motors	6	07-04-2003 23:20
Emergency drill trade/sell	Anarkissed	General Forum	3	16-02-2003 22:37
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32
what about the drill motors?	Ken Leung	Motors	2	26-06-2001 02:11

All times are GMT -5. The time now is 04:38.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.