|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#10
|
||||
|
||||
|
Re: Ohh Well another trans down the tube
Good grief how much does that transmission weigh? like 40#? we built one using the CIM (or whatever it is again) we have a high speed low tourque and low speed high tourque. it uses the CIM, aorund 10 1/4 inch gears and a pneumatic cylinder somewhere around 3" long. it only weighed aroung 8 pounds or less?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Has any one stuck a drill motor in the FP trans? | Lotownvw | Motors | 15 | 21-04-2003 23:57 |
| Aluminum Tube Source | archiver | 2000 | 3 | 23-06-2002 22:32 |