|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
||||
|
||||
|
Re: Trouble with pwm outputs
Okay, we finally figured some things out. PWM outputs require the 7.2V battery to be present for logic and supply. It should have been obvious to us when the red pin was associated with "7.2V," but apparently it wasn't. Whatever.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tether for new EduBot Controller | gburlison | Programming | 9 | 18-12-2003 17:53 |
| pwm 13-15 | wayne 05 | Programming | 2 | 04-10-2003 12:08 |
| PWM and burning out motors | patrickrd | Technical Discussion | 7 | 19-06-2003 15:30 |
| Hints For Rookie Programmers | Noah | Programming | 30 | 20-02-2003 20:07 |
| relay and pwm outputs | nick_champ_2 | Electrical | 1 | 31-01-2003 13:08 |