Plastic Motor Mount? - Chief Delphi

14-01-2004, 15:28

indieFan

RoboDox and LVHS - Missing you!

FRC #5941

Team Role: Engineer

Join Date: Jan 2002

Rookie Year: 2001

Location: Seattle (was SoCal, then SA,TX))

Posts: 382

Plastic Motor Mount?

I am currently trying to put the plastic motor mount over the Bosch drill. I finally managed to slip the drill into the large single piece, but I am finding that the three smaller pieces are not slipping on correctly. Are these pieces too small or am I doing something incorrectly?

I also moved the white ring closer to the clutch (I believe this is high gear) and locked it in place by rotating the black ring that the motor fits into 180 degrees. Could this be part of the problem?

indieFan

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
plastic hubs and drill motors	Will Camisa	General Forum	4	01-03-2003 00:03
What type of plastic is the	Adam Y.	Technical Discussion	1	28-01-2003 18:03
Plastic Retaining Rings	Adam Y.	Technical Discussion	9	15-01-2003 09:48
plastic boxes	Suzy	General Forum	6	12-01-2003 03:27
Plastic Spur Gears	Joe Canavan	Technical Discussion	2	25-11-2001 01:45

All times are GMT -5. The time now is 01:03.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.