|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
||||
|
||||
|
Re: Where to get 1/2" Flanged bearings?
sanddrag,
We used unground flanged 1/2" ball bearings from True Value Hardware in last year's single speed gearbox. No failures and the grearboxes have plenty of life still in them. I have switched to an R8 precision bearing for the dual speed gearboxes. This bearing is unflanged, the cost is not that high and they are readily available. I use button head screws on the outside to hold the outer race. I do not feel that the precision flanged 1/2" bearings are worth their cost for application. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reusing gearbox & bearings | BlacKnight6604 | Technical Discussion | 2 | 14-01-2004 21:49 |
| Cheapest place to get 3/8 inch ID double sealed flanged precision bearings? | Travis Covington | Technical Discussion | 5 | 24-02-2003 22:39 |
| Drills: The ball bearings are gone? | BobbyG | Motors | 0 | 21-01-2003 23:57 |
| A little tip about those drill transmissions and bearings | archiver | 2001 | 6 | 24-06-2002 00:22 |
| Skyway wheels w/o bearings | ahecht | Technical Discussion | 4 | 22-01-2002 01:25 |