|
|
|
 Even better than any [book] is simply becoming an active member of the Chief Delphi forums. Where do you think I got everything I know? - sanddrag [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Even better than any [book] is simply becoming an active member of the Chief Delphi forums. Where do you think I got everything I know? - sanddrag [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: Where to get 1/2" Flanged bearings?
You can also check out Small Parts . They have 1/2 inch bearings for around $6 or a pack of 10 for around $45. I do not see it listed with a flange on the small parts site, but I know if you ask for it you can get them flanged. The bearing that they sell is actually already in CAD on the www.firstcadlibrary.com site under the bearings section. You will also notice that the part number on the firstcadlibrary site is the one for small parts.
Eric |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reusing gearbox & bearings | BlacKnight6604 | Technical Discussion | 2 | 14-01-2004 21:49 |
| Cheapest place to get 3/8 inch ID double sealed flanged precision bearings? | Travis Covington | Technical Discussion | 5 | 24-02-2003 22:39 |
| Drills: The ball bearings are gone? | BobbyG | Motors | 0 | 21-01-2003 23:57 |
| A little tip about those drill transmissions and bearings | archiver | 2001 | 6 | 24-06-2002 00:22 |
| Skyway wheels w/o bearings | ahecht | Technical Discussion | 4 | 22-01-2002 01:25 |
Hybrid Mode
