IR sensors

Phil_Lutz · #1 18-01-2004, 14:57

You were given enough parts to make 2 Beacons.
In the sensor bag you will find Printed Circuit board x1, IR Transmittors x10 resistors x8, switches x2, and connectors x2.

Print out the document http://www2.usfirst.org/2004comp/Inf...ng_diagram.pdf
And it will assist you in the parts identification.

Phil

Kevin Watson · #2 18-01-2004, 15:16

Quote:

Originally Posted by Phil_Lutz

Print out the document http://www2.usfirst.org/2004comp/Inf...ng_diagram.pdf
And it will assist you in the parts identification.
Phil

This document is still incorrect. Pin 2 and 3 of Q1/"HexFET" need to be reversed for it to work.

-Kevin

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
what type of sensors are good and convenient	magical hands	Programming	7	04-01-2004 23:04
Q&A Discuss: Optical sensors with EduBot	CD47-Bot	Extra Discussion	2	01-03-2003 18:37
Q&A Discuss: optical sensors	CD47-Bot	Extra Discussion	0	15-02-2003 22:58
Robogui ! sensors don't work	Fares	Programming	2	07-01-2003 16:31
pre-built autonomous sensors?	BandChick	Technical Discussion	4	05-01-2003 22:06