mounting of the small gear directly to the shaft of the drill

FIRST doesn't just prepare you for engineering, it prepares you for life - sciguy125 [more]

		Chief Delphi > Technical > Motors
mounting of the small gear directly to the shaft of the drill

Thread Tools

Rate Thread

Display Modes

19-01-2004, 12:18

Andrew Dahl Andrew Dahl is offline

Registered User

#0497 (Orange Crush)

Join Date: May 2001

Location: Orange-VA

Posts: 160

Andrew Dahl is an unknown quantity at this point

mounting of the small gear directly to the shaft of the drill

is there an easy way to mount the smaller gear provided in the kit directly to the output shaft do the drill motor?

(its the one that does not accept the 5/8 chanelled rod through it)
and has not hub on it)

thanks

dahl

__________________
2002 VCU Regional winner of the GM Industrial Design award

whooot!

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Coupling the drill motor with out the 15 tooth gear	Chopper_Dave	Motors	1	17-01-2004 01:06
drill motor mounting	whynot	Technical Discussion	3	03-02-2003 08:24
Cheap small gear source	archiver	2000	2	23-06-2002 22:33
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32
Connecting new gear to shaft?	mnkysp6353	Technical Discussion	10	29-01-2002 05:12

All times are GMT -5. The time now is 07:58.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.