|
|
|
 I've managed to convince my wife that Valentine's Day is February 24th. :) - dtengineering [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I've managed to convince my wife that Valentine's Day is February 24th. :) - dtengineering [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
19-01-2004, 17:38
|
||||
|
||||
|
Re: How to turn down gear hubs?
Drill a couple of holes into the sprocket and screw it to a plate that has the same hole patteren as the sprocket and then clamp the piece to the mill. You could also try the same method with a lathe. The sprocket holder would just have to have a rod to go into the jaws of the lathe. Just some thoughts, I hope it helps, good luck
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Thunder Chicken CCT | Simon G | Motors | 4 | 03-01-2003 13:18 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drivetrain help | thedillybar | Technical Discussion | 9 | 08-01-2002 21:54 |
| Drivetrain Help | Jordan | Technical Discussion | 16 | 02-12-2001 12:14 |
| simple engineering question | Ben Mitchell | Technical Discussion | 2 | 07-11-2001 07:50 |
Threaded Mode