How to turn down gear hubs?

254 bends CIM shafts every now and then in the drivetrain. I didn't believe it was possible until I saw it myself. - AustinSchuh [more]

		Chief Delphi > Technical > Technical Discussion
How to turn down gear hubs?

Thread Tools

Rate Thread

Display Modes

19-01-2004, 19:21

Matt Reiland Matt Reiland is offline

'The' drive behind the drive

None #0226 (TEC CReW Hammerheads)

Team Role: Engineer

Join Date: May 2001

Rookie Year: 1999

Location: Troy Michigan

Posts: 712

Matt Reiland has a reputation beyond repute

Re: How to turn down gear hubs?

Sanddrag,

Last year I attached the hub to a shaft with a trantorque then milled it down. The trantorque kept the hub perfectly centered and you can reuse it over and over.

__________________
Robonaut Next Generation Control System Development

2003 GLR Champions (302,67,226)
2003 Buckeye Semi-Finalists(902,494,226)
2002 Nationals QuarterFinalists
2001 West MI QuarterFinalists
2000 GLR Semi-Finalists

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Thunder Chicken CCT	Simon G	Motors	4	03-01-2003 13:18
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32
Drivetrain help	thedillybar	Technical Discussion	9	08-01-2002 21:54
Drivetrain Help	Jordan	Technical Discussion	16	02-12-2001 12:14
simple engineering question	Ben Mitchell	Technical Discussion	2	07-11-2001 07:50

All times are GMT -5. The time now is 04:30.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.