|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||||
|
||||||
|
Bimba Pneumatics CAD site
I found this useful, so you all may think the same.
There is a nice site at Bimba that will let you download CAD files for their rotary actuator and cylinders. Here is the link. The cylinders are under "non-repairable stainless steel cylinders" and the rotary actuator is under "pneu-turn rotary actuator". Enjoy! Andy B. |
|
#2
|
||||||
|
||||||
|
Re: Bimba Pneumatics CAD site
Were you able to download anything? I put in a part number (178-DP for the 1-1/2 inch bore 8 inch stroke cylinder) and it doesn't recognize it for native ProE (which would be great for me). I tried a couple other part numbers and no luck - they do work on other parts of the website such as searching for cost so it looks like the part numbers are good.
|
|
#3
|
||||||
|
||||||
|
Re: Bimba Pneumatics CAD site
Quote:
Andy B. |
|
#4
|
|||||
|
|||||
|
Re: Bimba Pneumatics CAD site
I was using Bimba's CAD models just a few days ago. Very nice
![]() Gary: You could always just download the IGES format. Cory |
|
#5
|
||||||
|
||||||
|
Re: Bimba Pneumatics CAD site
Except I lose the parametrics when I go to IGES. If I could import it in ProE I could setup a parameter and the stroke position would change based on the position of the end points (or vice versa). I have a cylinder in there now with that feature, but it would be nice to have the other stuff located correctly such as ports
I'll check the other formats -step and IGES usually come in pretty clean but not parametric. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What do you use to make your team site!? | activemx | Website Design/Showcase | 68 | 15-01-2003 18:32 |
| NEW site dedicated to the UTC New England Regional! | archiver | 2001 | 2 | 24-06-2002 01:13 |
| CAD Drawings? | archiver | 1999 | 17 | 23-06-2002 22:35 |
| Excellent Inventor CAD site..... | Clark Gilbert | Inventor | 2 | 04-03-2002 00:50 |
| CAD file site update announcement ..... | Ed Sparks | General Forum | 0 | 13-01-2002 20:55 |