|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
|
|||
|
|||
|
Programming Port
Please note that the Basic Stamp uses the DTR signal on the programming port as a "Reset" line. When you download a new program, the editor changes the state of the DTR line to reset the processor before downloading.
I think the Dashboard Monitor program changes the DTR line when it initalize the COM port. Thus the program is reset. So it is better to have the cable plugged in first when you start up the Dashboard Monitor porgram. If you need more help on the RC connection with the Dashboard Monitor, please email me directly (liu@syrres.com) |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Impending BASIC Stamp Editor Beta 2 release | Greg Ross | Programming | 9 | 19-09-2003 06:05 |
| Basic Run Error | BBFIRSTCHICK | Programming | 10 | 02-04-2003 22:43 |
| Basic Init Error | yan184 | Programming | 5 | 14-12-2002 13:10 |
| BASIC error | punarhero | Programming | 4 | 16-02-2002 23:21 |
| BASIC Stamp Error | mpatterson | Programming | 4 | 22-01-2002 12:08 |