|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Each time im going to run the program so i can burp the compressor the error " Expected ':' or end-of-line" appears. Is there something wrong with the program.
.Also i need to find some tutorials for 3dsmax 4.2.ps is there a particular way in which you have to connect the OI and the computer so u can program the OI |
|
#2
|
||||
|
||||
|
well, you can't program the OI, cause it's not ment to be. for the error you're getting, it sounds like you renamed a variable, or misspelt one, and then you tried to set it equal to a number. i've gotten that a lot, and it's always been because of a stupid mistake i made, or becuase i was editing the code, and deleted something.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| EMERGENCY! EPROM FULL error?!? | CHSguard72 | Programming | 2 | 05-03-2003 20:51 |
| multi-bank programming problem | GregC | Programming | 3 | 14-02-2003 16:13 |
| Basic Run Error | Ulibrium | Programming | 12 | 21-02-2002 01:02 |
| Error found in programming for the pump and pressure switch | sjharobotics | Programming | 4 | 06-02-2002 17:46 |
| pbasic programming | punarhero | Programming | 4 | 21-01-2002 23:32 |