|
|
|
 Give us the e-mail address of these folks to send them a barrage of support letters for your students? - sanddrag [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Give us the e-mail address of these folks to send them a barrage of support letters for your students? - sanddrag [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Line Following -- Optical Sensors
I've been searching on here for info about using the Banner optical sensors for line following, but so far there isn't much info. Does anyone have any information about how to connect these to the RC? The data sheet from Banner shows a "load" connected to the black and white wires, but what kind of load? 50 ohm? Also, which wire is Vs and which is gnd? (Blue or Brown?)
Thanks! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Q&A Discuss: Optical sensors with EduBot | CD47-Bot | Extra Discussion | 2 | 01-03-2003 18:37 |
| Q&A Discuss: optical sensors | CD47-Bot | Extra Discussion | 0 | 15-02-2003 22:58 |
| Sprockets and Roller Chain Models | Madison | Inventor | 3 | 04-02-2003 11:51 |
| optical sensors acting strangely | rosebud | Electrical | 10 | 03-02-2003 00:29 |
| OPTICAL SENSORS??????????????????? | NM_programming | Technical Discussion | 2 | 13-01-2002 17:41 |
Threaded Mode