|
|
|
 Welcome to ChiefDelphi a month before Kick-Off. This is an annual traditional experience for quite a few regulars. - synth3tk [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Welcome to ChiefDelphi a month before Kick-Off. This is an annual traditional experience for quite a few regulars. - synth3tk [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||||
|
||||||
|
Compressor Flowrate Error in Catalog
Just a heads up. When I looked up the specs for the Thomas Compressor, I noticed that there was a discontinuity in the flow rate from 40 to 50 PSI in the chart. The graph makes more sense and I figured the numbers should be approximately:
10 PSI => .69 CFM 20 => .61 30 => .53 40 => .46 The rest of the chart seems correct. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Voice Activated commands | Amber H. | Technical Discussion | 40 | 03-11-2002 12:40 |
| Titanium Tubing (Small Parts Catalog) | archiver | 2001 | 5 | 23-06-2002 23:25 |
| Drill Motor and FP Motor Shaft Diameters | Andy Baker | Motors | 4 | 11-06-2001 20:12 |
Threaded Mode