|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||||
|
|||||
|
Re: 5/8 keyed shaft trouble
Aye, sandpaper most likely would most likely be your best bet. Hint on using it, roll the sandpapaer around the shaft so that you sand evenly the whole circumference of the shaft. It may take a while but it's easier than having to go out and shell out the bucks to purchase 5/8" shaft and have it machined and wait, or wait for keyed 5/8" shaft to come via mail. I hope that helps...God bless
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| supplier for 5/8" shaft | david.clark | Kit & Additional Hardware | 2 | 17-01-2004 18:13 |
| Problem with 5/8 in. shaft in this years kit | echos | Kit & Additional Hardware | 5 | 14-01-2004 21:21 |
| Can you stop a pneumatic pump at half shaft | mjt902 | Pneumatics | 16 | 06-02-2003 11:58 |
| Need Help on Shaft Mounting... | archiver | 2001 | 3 | 23-06-2002 23:29 |
| shaft drive | Joseph F | Technical Discussion | 5 | 03-02-2002 17:51 |