|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#12
|
|||||
|
|||||
|
Our controls had a basic error too, but it ran perfect. The robot one didn't pick it up, i think, but our driver-controller did. That little red light stayed on, or until i put duck tape over it. Haha, little red, basic error light, who has the upper hand now?
Just put a strip of duck tape when you see your robot agian, and all will be well. Just give it 2-3 hours to let the duck tape act as a bandage, and there u go, brand new robot! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Impending BASIC Stamp Editor Beta 2 release | Greg Ross | Programming | 9 | 19-09-2003 06:05 |
| Basic Run Error | BBFIRSTCHICK | Programming | 10 | 02-04-2003 22:43 |
| Basic Init Error | yan184 | Programming | 5 | 14-12-2002 13:10 |
| BASIC error | punarhero | Programming | 4 | 16-02-2002 23:21 |
| BASIC Stamp Error | mpatterson | Programming | 4 | 22-01-2002 12:08 |