|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||||
|
|||||
|
Re: Inventor Library
I think the only place we used the 5/8 ID bearing was for the wheel axles, which only show up in the final assembly. Here's the link for that download: Final Robot. Unfortunately, that is the whole robot assembly - all 150+MB.
If you go to cbliss.com, he has a great selection of iPart bearings here. Last edited by petek : 28-01-2004 at 14:13. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|